Charged Reviews · Quick reference
Panasonic EVPV360
- Brand
- Panasonic
- Model
- EVPV360
- SKU / part number
- EVPV360 Provisional [1]
- Category
- Solar panels
chargedreviews.com/panels/panasonic-evpv360
Electrical at STC
- Module efficiency
- 20.6 % Provisional [1]
- Power tolerance
- ?
Temperature and system limits
Cells and construction
- Cell technology
- Silicon hetero-junction Needs confirmation [3]
- Cell count
- ?
- Bifacial
- ?
- Bifaciality
- ?
- Frame
- ?
- Front glass
- ?
- Back cover
- ?
- Panel format
- ?
Mechanical and connections
- Connectors
- ?
- Cable length
- ?
- Junction box rating
- ?
- Mounting
- ?
- Design load, front
- ?
- Design load, rear
- ?
Installation (from the manual)
Torque
- Clamp or bolt torque
- 8.8 to 18.4 ft-lb [3]
Conductors
- Cable bending radius / connector notes
- The cables must have a minimum bending radius of 1.2 in (30 mm) to avoid damage to the insulation [3]
Clearances and orientation
- Mounting methods and clamp zones
- Installing the EVERVOLT® modules with clamps and rails has been found to comply with UL 61730 requirements for downward pressure, e.g., snow, of up to 7000 Pa (4666 Pa design load*) and upward pressure, e.g., wind, of up to 4000 Pa (2666 Pa design load*); The module must be secured, e.g., clamped, at least once in each of the four marked zones shown below (Figure. 8).; MOUNTING EVPXXX SERIES AND EVPVXXXK SERIES WITH CONTINUES RAILS PARALLEL TO SHORT SIDE OF THE MODULE; MOUNTING EVPVXXX AND EVPVXXXK SERIES WITH CONTINOUS RAILS PARALLEL TO LONG SIDE OF THE MODULE; MOUNTING EVPVXXX AND EVPVXXXK SERIES WITH SHORT RAILS; Installing the EVERVOLT® modules using the mounting holes has been found to comply with UL 61730 requirements for downward pressure,e.g., snow, of up to 5400 Pa (3600 Pa design load*) and upward pressure,e.g., wind, of up to 2400 Pa (1600 Pa design load*); All four mounting holes in the frame must be used (Figure 21). [3]
Grounding
- Grounding
- EVERVOLT® modules have a small round grounding hole positioned near each corner of the module on both the long side and the short side; Suitable grounding lugs must be used: Listed (KDER) ILSCO, GBL- 4DBT (tin plated) (E34440); Grounding cable size should be between 4 - 14 AWG (2.1 mm² - 21.2 mm²); Fix lug to the frame using a star washer and lock nut, ensuring a conductive connection [3]