Charged Reviews · Quick reference
LG Electronics LG365Q1C-V5 NeON R Module
- Brand
- LG Electronics
- Model
- LG365Q1C-V5
- SKU / part number
- ?
- Category
- Solar panels
chargedreviews.com/panels/lg-electronics-lg365q1c-v5
Electrical at STC
Temperature and system limits
- Temperature coefficient, Pmax
- -0.3 %/°C [1]
- Temperature coefficient, Voc
- -0.24 %/°C [1]
- Temperature coefficient, Isc
- 0.037 %/°C [1]
- Maximum system voltage
- 1,000 V [1]
- Maximum series fuse
- 20 A Needs confirmation [2]
- NOCT / NMOT
- 44 °C / 111 °F converted Needs confirmation [2]
- Rated output at NMOT
- 274.7 W Needs confirmation [2]
- Operating temperature
- -40 to 90 °C / -40 to 194 °F converted [1]
Cells and construction
Mechanical and connections
Installation (from the manual)
Torque
- Clamp or bolt torque
- 8 to 12 N·m Needs confirmation [2]
Conductors
- Cable bending radius / connector notes
- Cable bending radius should be more than 4 times the cable diameter, at least. Needs confirmation [2]
Clearances and orientation
- Mounting methods and clamp zones
- Module Strength(Basic Load) ; IEC61215-2:2016: 60Cell, Front Side: Design Load 3600 Pascal, Test Load 5400 Pascal; Rear Side: Design Load 2650 Pascal, Test Load 4000 Pascal; mounting distance ① : 200mm ② : 300mm, by using frame bolt holes; Fig.1 Bolting Type: ① : 200mm, ② : 300mm; Front : 5400Pa Rear : 4000Pa; Fig.2 Clamping Type: A : 200mm, B : 400mm; Front : 5400Pa Rear : 4000Pa; A : 0mm, B : 650mm; Front : 2400Pa Rear : 2400Pa; Fig.3 Clamping Type: A : 200mm, B : 400mm; Front : 4000Pa Rear : 4000Pa; Fig.4 Clamping Type: A : 200mm; Front : 1800Pa Rear : 1800Pa; B : 200mm; Front : 2400Pa Rear : 2400Pa; Fig.5 Clamping Type: A : 200mm, B : 400mm; Front : 5400Pa Rear : 4000Pa; C : 120mm; Front : 5400Pa Rear : 1800Pa; Fig.6 Clamping Type: A : 120mm *4point(①); Front : 1800Pa Rear : 1800Pa; A : 120mm, B : 843 ±100mm 6point(①+②); Front : 5400Pa Rear : 4000Pa Needs confirmation [2]
Grounding
- Grounding
- One M4 stainless steel bolt, one nut, one spring washer, two flat washers, one cup washer, one star washer and 12 AWG Cu wires are recommended per mounting hole.; There is an earth hole on the edge of the module frame.; All screws and nuts shall be tightened to a torque of 4~5 N∙m. Needs confirmation [2]